Transducer Shield & Saver TM-DI-2

Description

TM-DI-2 fits Humminbird Down Image Xducer # XNT 9 DI T (RD) for Trolling Motor, Jack Plate or Set Back

TM-DI-2 fits Humminbird® Down Image Transducer # XNT 9 DI T (RD) for trolling motor, set back or jack plate installation. It DOES NOT fit the ORIGINAL Down Image transducer # # XNT 9 DI T.

ITEM # TM-DI-2 is built in High Quality Aluminum Alloy and Black Powder Coated. The Sleek and Hydrodynamic design will reduce collection of debris and keep the transducer positioned correctly and will not interfere with the transducer signal. This Transducer Shield® can also be attached to any of our L Brackets for installing on the side of your jack plate OR on a Wedge for installing on a hole shot plate (under the jack plate) or Set Back on some boats.

It is uniquely designed to fit the Humminbird® redesigned Down Image Transducer # XNT 9 DI T (RD). It is very important that you know YOUR check the number on YOUR transducer number because Humminbird® HAS NOT changed the transducer number on their website. If your transducer does not end with (RD) go to Transducer Shield # TM-DI which will fit down image transducer # XNT 9 DI T. For more information, please read notes (1) and (2) below:

(1) The original Down Image Transducer XNT 9 DI T the cable comes out on the RIGHT and the transducer is rounded at the back. This transducer is approximately 4-3/4″ long x 1-1/2″ wide. The transducer number is labeled on the cable close to the plug. If the transducer number ends with a T please choose Transducer Shield # TM-DI
(2) The redesigned Down Image Transducer XNT 9 DI T (RD) the cable comes out on the LEFT and the transducer is flat at the back. This transducer is approximately 5″ long x 1-3/4″ wide. The transducer number is labeled on the cable close to the plug. If the transducer number ends with (RD) it will fit Transducer Shield # TM-DI-2