Transducer Shield & Saver TS-LSS2-L

Description

TS-LSS2-L fits Lowrance LSS2 Structure Scan Transducer on a Jack Plate

Easily attaches a Lowrance® LSS2 structure scan transducer, with ADDITIONAL components to your Jack Plate or Boat Set Back.

Item # TS-LSS2-L is built in High Quality Aluminum Alloy and Black Powder Coated. It is designed to fit Lowrance® LSS2 (10-1/4”) Structure Scan Transducer. This item DOES NOT fit the Lowrance® LSS1 (6”) Structure Scan transducer. Please go to TS-LSS-1 if you have the shorter transducer.
The Sleek Hydrodynamic Design will cut through the water for less drag, reduces collection of debris, keeps the transducer positioned correctly and will not interfere with the transducer signal.

Item TS-LSS2-L along with additional accessories can easily be bolted to the side of a Jack Plate, on the Hole Shot Plate under the Jack Plate, OR on the boat set back. For this installation, please see L Brackets or Wedges. When installing a Structure Scan transducer it is important to be aware that an in hull transducer will also be required. The Structure Scan transducer signal picks up trees and structure etc. A pod or skimmer transducer will pick up fish, depth and will separate the fish from the structure. Resulting in the best performance when the boat is up on plane.

Item TS-LSS2-L is approximately 10-1/2” long and cannot be installed on a trolling motor. If you were planning on installing an LSS2 transducer on your trolling motor, then please see Item # TS-LSS2-3D.
Warning: Motorguide® 55lb thrust and below OR Minnkota® 70 lb thrust and below, additional components will be required.